- 您现在的位置：买卖IC网 > Sheet目录395 > AS3930-BQFT (ams)IC RF PROGRAM RECEIVER 16-QFN
AS3930
Datasheet - D e t a i l e d D e s c r i p t i o n
AS3930 needs the following external components:
?? Power supply capacitor – CBAT – 100 nF
?? 32.768 kHz crystal with its two pulling capacitors – XTAL and CL (it is possible to omit these components if the internal RC oscillator is used
instead of the crystal oscillator)
?? Input LC resonator
In case the internal RC-oscillator is used (no crystal oscillator is mounted), the pin XIN has to be connected to the supply, while pin XOUT should
stay floating. Application diagrams with and without crystal are shown in Figure 1 and Figure 2 .
8.1 Operating Modes
8.1.1
Power Down Mode
In Power Down Mode, AS3930 is completely switched off. The typical current consumption is 400 nA.
8.1.2
Listening Mode
In listening mode only the channel amplifier and the RTC are running. In this mode the system detects the presence of a carrier. In case the
carrier is detected, the RSSI can be displayed.
In this mode it is possible to distinguish the following three sub modes:
Standard Listening Mode. The channel amplifier that is capable of detecting the presence of the carrier frequency, is active all the time.
ON/OFF Mode (Low Power Mode). The channel amplifier is active for one millisecond after which it is switched off. The OFF-time is
programmable (see R4<7:6> ).
Figure 11. ON/OFF Mode
Channel
t0
t0 + 1ms
t0 + T
t0 + T + 1ms
t0 + 2T
Time
Presence
of Carrier
Time
Further, for both sub modes, it is possible to enable a feature called Artificial Wake-up. If the Artificial Wake-up is enabled, then the AS3930
produces an interrupt after a certain time regardless of whether any activity is detected on the input. The period of the Artificial Wake-up is
defined in the register R8<2:0> . The user can distinguish between Artificial Wake-up and Wake-up based on the field detection (frequency or
pattern detection) since the Artificial Wake-up interrupt lasts only 128μs. With this interrupt the microcontroller ( μ C) can get feedback on the
surrounding environment (e.g. read the false wake-up register R13<7:0> ) and/or take actions in order to change the setup.
8.1.3
Preamble Detection / Pattern Correlation
The preamble detection and pattern correlation are only considered for the wake-up when the data correlator function is enabled. See R1<1> .
The correlator searches first for preamble frequency (constant frequency of Manchester clock defined according to bit-rate transmission, see
Table 19 ) and then for data pattern.
If the pattern is matched, then the wake-up interrupt is displayed on the WAKE output and the chip goes in data receiving mode. If the pattern
fails, then the internal wake-up is terminated and no IRQ is produced.
www.ams.com/LF-Receiver/AS3930
Revision 1.5
11 - 32
发布紧急采购，3分钟左右您将得到回复。
相关PDF资料
AS3930-BTST
IC ASK RECEIVER 1CH LP 16-TSSOP
AS3931-ZTSU
IC ASK RECEIVER LF 3CH 16-TSSOP
AS3932-BTST
IC RF PROGRAM 16-TSSOP
AS500106
TLAPS MAGNET CARRIER
AS5263-HQFT-500
IC ENCODER ROTARY 12BIT 32-QFN
AT 150 B420L
SENSOR CURRENT 150A 30V MOD
AT 150 B5
SENSOR CURRENT 150A MOD
AT 20 B10
SENSOR CURRENT 20A MOD
相关代理商/技术参数
AS3930-BTST
功能描述:IC ASK RECEIVER 1CH LP 16-TSSOP RoHS:是 类别:RF/IF 和 RFID >> RFID IC 系列:- 其它有关文件:CR14 View All Specifications 标准包装:1 系列:- RF 型:收发器 频率:13.56MHz 特点:ISO14443-B 封装/外壳:16-SOIC（0.154"，3.90mm 宽） 供应商设备封装:16-SO 包装:Digi-Reel® 其它名称:497-5719-6
AS3930-DB
制造商:ams 功能描述:AS3930 Demo Board
AS3931
制造商:AMS 功能描述:AS Series 19 to 150 kHz Surface Mount 3D Wakeup Receiver - TSSOP-16
AS3931 DB
制造商:AMS 功能描述:BOARD DEMO FOR AS3931 制造商:AMS 功能描述:Demoboard for AS3931 3D Low Power Wakeup Receiver
AS39310FLF
制造商:TT Electronics / IRC 功能描述:AS39310FLF
AS39310HLF
制造商:TT Electronics / IRC 功能描述:AS39310HLF
AS39310JLF
制造商:TT Electronics / IRC 功能描述:AS39310JLF
AS39311FLF
制造商:TT Electronics / IRC 功能描述:AS39311FLF